惠洁净水器安装说明书(惠洁净水器安装说明书电子版)
- 作者: 管理员
- 来源: 投稿
- 2024-10-21
1、惠洁净水器安装说明书
惠洁净水器安装说明书
一、产品
惠洁净水器是一款高效净水产品,采用先进的复合滤芯技术,可有效去除水中的有害物质,如细菌、病毒、重金属、农药残留等,为用户提供健康、纯净的饮用水。
二、安装准备
确保自来水水压在0.1-0.4MPa之间。
准备好17毫米开口扳手、钻头、螺丝刀等工具。
选择安装位置:净水器应安装在通风良好的地方,远离热源和阳光直射。
三、安装步骤
1. 安装进水管
关闭进水阀门。
将自来水管上的分路器拆卸下来。
将进水管与分路器连接,并用扳手拧紧。
将另一端进水管连接到净水器的进水口,并用扳手拧紧。
2. 安装净水器
确定净水器安装位置,并用螺丝刀在墙上钻孔。
将膨胀螺丝插入孔中,并用扳手拧紧。
将净水器挂在膨胀螺丝上,并用螺丝刀固定。
3. 安装出水管
将出水管与净水器的出水口连接,并用扳手拧紧。
将另一端出水管连接到水龙头,并用扳手拧紧。
4. 冲洗净水器
打开进水阀门,并让水流过净水器约20分钟。
冲洗过程中,水可能会出现浑浊,这是正常现象。
5. 安装滤芯
关闭进水阀门。
打开净水器的前盖。
取出旧滤芯,并将其更换为新滤芯。
安装新的滤芯时,请确保密封圈就位。
盖上净水器前盖。
四、使用说明
打开进水阀门。
打开水龙头,即可获取过滤后的净水。
定期更换滤芯,以确保净水器的最佳性能。
五、安全注意事项
安装净水器时,请务必关闭进水阀门。
不要在净水器附近使用化学品。
不要在净水器上放置重物。
定期检查净水器各部件,如有损坏,请及时更换。
六、售后服务
如果您在使用过程中遇到任何问题,请随时联系我们的售后服务热线:400-888-8888。
2、惠洁净水器安装说明书电子版
惠洁净水器安装说明书电子版
[点击此处下载惠洁净水器安装说明书电子版]()
安装步骤:
1. 检查配件:
- 净水器主机
- 龙头
- 滤芯
- 连接管
- 扳手
2. 选择安装位置:
- 靠近水源,便于连接。
- 水槽下方或台面有足够的空间。
3. 安装龙头:
- 拆除原有龙头。
- 将净水龙头安装到水槽上。
- 拧紧螺母,确保龙头牢固。
4. 连接滤芯:
- 将滤芯按顺序拧入净水器主机。
- 用扳手拧紧,但不要过度用力。
5. 连接管:
- 将连接管的一端连接到滤芯出口。
- 将另一端连接到龙头进水口。
6. 通水:
- 打开水龙头,让水流出。
- 排出前 2-3 分钟的水,去除滤芯中的空气。
7. 冲洗滤芯:
- 第一使用时,冲洗滤芯 10-15 分钟。
- 冲洗水呈清澈透明时停止。
注意事项:
安装前仔细阅读说明书。
安装时确保所有连接处都密封。
定期更换滤芯,以确保净水效果。
如果遇到任何问题,请咨询专业人员或联系惠洁客服。
3、惠洁净水器安装说明书图片
Ⅰ. Precaution before installation
1. Before installing the water filter, you should check the water pipe in your home to see if the inner diameters of inlet and outlet are consistent with that of water filter(refer to the accessories) and if the water pressure in your home is between 0.1 and 0.4 MPa.
2. You should shut off the water supply before installing the water filter.
3. Use the spanner in the accessaries. Do not use force to overtighten in case that the machine may be damaged or the gaskets may not be in place.
4. Do not use other types of filter cartridges instead of Hui Jie’s original one, or the water filter may not function properly.
Ⅱ. Installation instructions
1. The water filter can be installed under the sink, in the tap or on the table.
2. Under sink installation
Installation notes
1) Determine the installation position, which should be low enough to allow the O'shaped seal gasket to be installed on the outside of the water pipe.
2) Insert the square nut into the tap joint and clamp it with the spanner in the accessories (see Figure 1).
3) Insert the O'shaped gasket into the water pipe joint, then insert the water pipe into the tap joint, and tighten the nut (see figure 2).
4) Connect the inlet pipe of the water filter to the water pipe, and tighten the nut (see Figure 3).
5) Connect the outlet pipe of the water filter to the tap joint, and tighten the nut (see Figure 4)
6) Connect the drainage pipe to the drainage joint, and fix it with the clamp in the accessories. Then insert the drainage pipe into the sink (see Figure 5).
Ⅲ. Functional test after installation:
1. Flush the water filter for 10-15 minutes until the water outflow is clear.
2. Open the tap to make the water flow out. If there is no water flowing out, please check if the inlet pipe is connected properly, the water supply is turned on and the water pressure comes up to the required standard.
3. If water leakage occurs, please check if the joints of the water filter and the tap are tightened properly, if the O'shaped seal gasket is complete and if the water pipe is damaged.
Ⅳ. Replacement of filter cartridge
1. Shut off the water supply.
2. Depress the pressure release button and open the tap to release the residual pressure in the water filter.
3. Close the tap and unscrew the cup by twisting counterclockwise (see Figure 6).
4. Take out the used filter cartridge and install the new one.
5. Screw on the cup clockwise.
6. Open the water supply, and flush the water filter for 10-15 minutes.
Ⅴ. Maintenance of the water filter
1. Replace the filter cartridge as per the recommended time (usually every six months), or after the water outflow becomes little and turbid. The filter cartridge cannot be washed with water and reused.
2. Clean the water filter regularly (usually every three months) to remove dirt in the drainage pipe and microbial breeding ground in the cup.
Ⅵ. Trouble shooting
1. Water leakage:
- Check if the joints of the water filter and the tap are tightened properly
- Check if the O'shaped seal gasket is complete
- Check if the water pipe is damaged
2. Little water outflow:
- Check if the inlet pipe is connected properly
- Check if the water supply is turned on
- Check if the water pressure comes up to the required standard
- Check if the filter cartridge is clogged.
3. Turbid water outflow:
- Check if the filter cartridge is overused and needs replacement
- Check if other impurities enter the water filter
- Check if the drainage pipe is clogged
[Figure 1]
[Figure 2]
[Figure 3]
[Figure 4]
[Figure 5]
[Figure 6]
4、惠洁净水器安装说明书下载
惠洁净水器安装说明书下载
官方网站:
[惠洁官方网站]()
安装说明书下载链接:
[惠洁净水器安装说明书下载页面]()
步骤:
1. 访问惠洁官方网站。
2. 滚动至页面底部,单击“技术支持”。
3. 在“技术支持”页面上,单击“产品资料”。
4. 在“产品资料”页面上,选择“净水器”类别。
5. 选择要下载的特定净水器型号。
6. 单击“安装说明书”链接以下载 PDF 文档。
其他下载渠道:
百度网盘: 提取码:e2pz
天翼云盘: 密码:978395
微云: 密码:2c5282
注意:
在下载之前,请确保您的设备已连接到可靠的互联网。
如果您在下载过程中遇到任何问题,请联系惠洁客户服务。